deskthority

Today I found a IBM 3278-2 computer terminal from my basement. It was there lying around in dust with some scrapes here and there. Keyboard was sadly missing I don't know if it is working, but I plan to find out this weekend.

I am curious what is this beauty worth.

Thanks Muirium for the quick answer! I am writing this on a fully working Model M with custom macros! Thank you! I will post pictures as soon as the board is cleaned.

Thanks Muirium for the suggestions! I will try those now. Do you think it matters that the firmware version is 1.12 and tools are 1.10? (I could not find tools for the 1.12 version)

I finally got my Model M working with Pro Micro flashed with Soarer's converter, but some keys are mapped wrong. I would like to fix this and have created a config binary file, but scwr doesn't recognize my pro micro as converter. Any ideas on what I am doing wrong?

The new Pro Micro arrived today and this time I used the Soarer's Converter instead of TMK. My Model M woke up! It lives! Thanks for everybody for their input! This keyboard feels amazing!

Some keys are mapped wrong and I followed Soarer's instructions on this, but scwr did not find Soarer's ...

Okay. There is so much tin on the pro micro that I have decided to order a new one from Hong Kong.

For next time though, what exactly should I do?

I am thinking of wiring the DATA to RX and CLOCK to PC6 with tmk setup like this:

#define PS2_CLOCK_PORT PORTC
#define PS2_CLOCK_PIN PINC
#define PS2 ...

Findecanor : No I have not bridged the jumper. Thanks for the information!

Redmaus : I will look into this, thanks!

keiwop :

So my current CLOCK is in the right pin? Something went right after all :P

I much rather would change the soldering setup. I had so much trouble with the flashing and ...

Okay, now I am clueless.

I successfully flashed my pro micro and have tried two different ways to solder my model m to it but with no luck.

Here is what I get with ' watch "dmesg | tail" '':

[186349.519329] usb 3-2: USB disconnect, device number 5
[187502.624006] usb 3-2: new full-speed USB ...

Oh yes! I got it to work! Thank you so much! Apparently I was too hasty with the RST + GND shorting.

Yes the device I am trying to flash is /dev/ttyACM0 .
I have some code to write and deadlines are getting closer, but I will continue later today and also send the commandline I have used so far.

Have a nice trip!

I used the 'watch "dmesg | tail"' and got a response like this:
[ 7353.955579] brcmsmac bcma0:0: START: tid 1 is not agg'able
[ 8270.225369] usb 3-2: new full-speed USB device number 26 using xhci_hcd
[ 8270.356352] usb 3-2: New USB device found, idVendor=2341, idProduct=8036
[ 8270.356363] usb 3-2 ...

I have Ubuntu 14.04 and Windows 7 on my laptop. I am currently using Ubuntu to flash my pro micro. I will try that dmesg trick. Thanks for the quick responses!

I think so yes. Does something flashy happen when I connect the GND and RST twice? In other words: How do I know if my pro micro is in boot mode?

I am having problems with avrdude:
avrdude: butterfly_recv(): programmer is not responding.

This error occurs when I try to run:
avrdude -p atmega32u4 -P YOUR_SERIAL_PORT -c avr109 -U flash:w:filename.hex
where I have replaced YOUR_SERIAL_PORT and filename.hex with proper ones.

Does someone know ...